3D Druck sollte man nicht verpassen
Hoffe es kommt anders!
"We are disappointed with our overall results and the lower revenue from our 3D printing products and services, which we believe were negatively impacted by continued challenging market conditions that extended customers' capital investment cycles and reduced demand across all geographies," commented Andrew Johnson, Interim President & Chief Executive Officer and Chief Legal Officer, 3D Systems. "However, we are pleased that our 3D healthcare simulators and services and 3D software contributed favorably to our results."
Gross profit margin decreased 90 basis points compared to the third quarter of 2014 to 46.9% due primarily to the negative impact of consumer products.
For the third quarter of 2015, operating expenses remained flat sequentially at $105.7 million, inclusive of $22.5 million of R&D expenditures and an $11.3 million expense for an arbitration award related to a business acquisition completed in 2011.
The company reported a third quarter GAAP net loss of $32.2 million, or a $0.29 loss per share. The company reported non-GAAP net income of $0.8 million, or $0.01 earnings per share.
The company used $4.3 million of cash for operations during the quarter and had $157.5 million of cash on hand at the end of September.
For the first nine months of 2015, revenue grew 4% to $482.8 million, or a 12% increase on a constant currency basis, resulting in a GAAP loss of $0.53 per share and non-GAAP earnings of $0.08 per share.
"As we navigate challenging market conditions, we are taking decisive steps to reduce our cost structure and better prioritize our resources around near-term opportunities while continuing investments in quality initiatives, partner-centric programs and new products," concluded Johnson.
SSYS ist schon teilweise bei 21 € angekommen, bisher scheint die Richtung abwärts zu sein.
Wer den Kitzel braucht:
http://de.advfn.com/...0&height=600&min_pre=0&min_after=0
http://www.zdnet.de/88250899/...tschland-mit-verkauf-von-3d-druckern/
Das könnte schon was werden. Vertriebswege und Service von Canon ist eingespielt.
Vom Chart sehe ich 3D Systems im Tal. Es scheint so ein Boden zu sein. Ein Scenario, welches zum Einsteigen einlädt.
Keine Logik hier, einfach gezocke...
Verstehen kann man das wohl letztendlich nicht. Da fehlt die Logik oder die Wenn Dann Formel geht manchmal nach hinten los.
Kommentar: es kann nun nur noch besser werden!
darüber wird der zeitweise Schmuh den man hier betreibt auch nicht hinweg täuschen.